Best Ideas

The deck on a house is a floored area that extends from the house and is normally roofless. It can be situated at the back, the front or to the side of the house. Deck railings provide a deck its style and distinctiveness and are very crucial in keeping persons safe in that, they are both functional and decorative. In being decorative, they are attractive components adding design to a house and are practical as they enhance protection. It is usually required for decks that are higher than thirty inches above the ground and also for stairs that comprise of five or over steps. The height of a deck railing normally ranges between thirty and forty inches even though specific areas have particular constraints. Standard builder deck railings are the simplest types to make and install.


Deck railings contain a top rail and a bottom rail, side rails and may also contain bulging posts, balusters and hand rails. They come in a variety of styles and can be made from different materials including iron, aluminum, natural timber, wood composite materials and also transparent glass. They are readily accessible, but believe it or not, you can make a deck railing by yourself. Are you curious? Heres how:

• 2 x 2 inches wood

• Carriage bolts

• 2 x 4 inches wood

• 2 x 6 inches wood

• Galvanized screws

• 1 can varnish stain

• Tools Required:

• Wood saw

• Electric drill

• Screwdriver

• Paintbrush

• Knife

#1. Get rid of any wood or material that is connected to the deck so that you will locate the rim joist which is the outermost part of the flooring.


#2. Use 2 x 6 inches wood to create the upper railing and attach it for the time being to the deck by using a screwdriver and galvanized screws.


#3. Using your wood saw cut the 2 x 2 inches wood to the relevant height for the spindles.


#4. Use the electric drill and make two holes into every spindle. One hole must be drilled approximately 1 1/2 inches from the base of the deck. The other hole should be made 1 ½ inches from the top and the outside of the deck. These holes must be smaller than the carriage bolts.


#5. For strength and firmness, bolt the spindles into position with the carriage bolts.


#6. Cut the 2 x 4 inches wood with the saw to the correct lengths to make spindles. Ensure that they are the same lengths as any mistake will be obvious.


#7. Using your screwdriver, join the sections you cut to each spindle using the galvanized screws.


#8. Permanently screw the railings to the deck at this stage. Screw through the bottom to raise the railing.


#9. Use knife to pry open the can of varnish stain.


#10. Take paintbrush and slightly dip it into the can of varnish stain to soak up a little.


#11. Paint the railings by applying level strokes with the paintbrush and continue until the total railing is finished.




Always construct your deck railings in compliance with rules regarding them in your area.


Spindles should be spaced no more than nine inches apart for security.


Carefully measure at every step to get a look that is as skilled as possible.


Painting or staining the wood seals it to make it more durable.


The railing should be about 4 inches high but allow added length so that it flushes with the bottom outside section of the deck.


The stairs leading to the deck must be in position to give easy access to the deck.


Select a railing style that suits is within your means and blends with the model of your house.